We can't find the internet
Attempting to reconnect
12723.2;6 PFIW-IW
PerWoodCut- Performance wood cutting via a light weight ceramic matrix composite knife based tool system for high speed industrial wood machining.
Résumé
PerWoodCut- Performance wood cutting via a light weight ceramic matrix composite knife based tool system for high speed industrial wood machining.
Textes supplémentaires
Abstract
A complete lightweight high speed solution for industrial cutting of wood is proposed. This can only be done with significantly lighter cutting tips than those today (WC, p =15-16 g/cm3). Using a lightweight ceramic matrix composite (CMC) cutting tip (p =4-6 g/cm3) allows a light weight tooling system to be used which allows the cutting speeds to be doubled. Such a silicon nitride/ silicon carbide CMC was shown to be an alternative to WC but was found to be commercially too expensive (CTI project CerWoodCut). An alumina-zirconia matrix CMC which can be reinforced with hard, wear resistant particles will be developed as part of lightweight tool system.
Participants
Jakob Kübler
Kontaktperson
jakob.kuebler@empa.ch
EMPA Jakob Kübler Ueberlandstrasse 129 8600 Dübendorf ZH CH
Détails du projet
- Office de recherche
- INNOSUISSE
- Statut du projet
- Abgeschlossen
- Type de projet
- Forschungsprojekt
- Date de début
- 2011-10-31
- Date de fin
- 2015-01-05
- Coûts totaux approuvés
- CHF 296414.00
- Section
- 23 Förderbereich Engineering
- Domaine politique NABS
- Nicht aufteilbare / nicht zuteilbare Forschung
Disciplines de recherche
- T150 Material technology 100.0%