Zurück zu Projekte

12723.2;6 PFIW-IW

PerWoodCut- Performance wood cutting via a light weight ceramic matrix composite knife based tool system for high speed industrial wood machining.

Zusammenfassung

PerWoodCut- Performance wood cutting via a light weight ceramic matrix composite knife based tool system for high speed industrial wood machining.

Weitere Texte

Abstract

A complete lightweight high speed solution for industrial cutting of wood is proposed. This can only be done with significantly lighter cutting tips than those today (WC, p =15-16 g/cm3). Using a lightweight ceramic matrix composite (CMC) cutting tip (p =4-6 g/cm3) allows a light weight tooling system to be used which allows the cutting speeds to be doubled. Such a silicon nitride/ silicon carbide CMC was shown to be an alternative to WC but was found to be commercially too expensive (CTI project CerWoodCut). An alumina-zirconia matrix CMC which can be reinforced with hard, wear resistant particles will be developed as part of lightweight tool system.

Beteiligte

Jakob Kübler

Kontaktperson

jakob.kuebler@empa.ch

EMPA Jakob Kübler Ueberlandstrasse 129 8600 Dübendorf ZH CH

Projektdetails

Forschungsstelle
INNOSUISSE
Projektstatus
Abgeschlossen
Projekttyp
Forschungsprojekt
Startdatum
2011-10-31
Enddatum
2015-01-05
Bewilligte Gesamtkosten
CHF 296414.00
Sektion
23 Förderbereich Engineering
NABS Politikbereich
Nicht aufteilbare / nicht zuteilbare Forschung

Forschungsdisziplinen

  • T150 Material technology 100.0%